patona BP-U60 Battery Pack 75Wh

ROKO BP-U90 High capacity lithium ion battery for Sony BP-U camcorders. Can be transported in an airplane according to IATA regulations. Equipped with the newest infochip to support Sony PXW-FS5 and PXW-FS7. The ROKO BP-U90 is the ideal solution if you need a battery with good stamina. This battery has a capacity of 95 wh whch is enough to power a Sony PMW300 for up to five hours straight through. You can use this battery with other cameras than the PMW-series as well. The battery is equipped with the newest infochip which supports cameras like the Sony PXW-FS5 and PXW-FS7 without struggle. The ROKO BP-U90 works just like the battery that was supplied with your camera. The infochip makes communication possible between camera and battery. You can see the remaining running time as well as a symbol indicating the remaining capacity of the battery. When the camera is switched off, you can get a rough idea of the capacity just by pressing the check button on the battery. This will light up to four LEDs depending on the current status. Please keep in mind that the housing of this battery is pretty large. While the width and height are just the same as with the ROKO BP-U60, the length might be a problem because the battery can stick out of the battery compartment. With the FS7 it is not a problem at all, because this camera seems to be designed for such long batteries. Still, 15mm will stick out a bit though. The built in lithium ion cells are made by Samsung. The battery can be charged with the charger supplied with your camera. You can use third party chargers for it as well. This battery can be transported in airplanes since the overall capacity does not exceed 100 Wh. IATA travel restrictions do not apply to this battery. Technical specifications voltage: 14.4 Voltcapacity: 6600 mAhpower: 95.04 Wh  cell type: Lithium Ioncells manufacturer: Samsung  max. power draw: 63 Whcompatible with: Sony BP-U Systemreplaces: BP-U30, BP-U60, BP-90  dimensions: ca. 120 x 69 x 41 mmweight: ca. 560 g

Hawk-Woods BP-98UX The Hawk-Woods BP-98UX has been designed, manufactured and tested to be a direct replacement for Sony BP-U type batteries. With a built-in fuel gauge & Hawk-Woods build quality, the high-tech Li-Ion BP-98UX camera battery offers stunning performance for its size and weight and unlike many replacement BP-U batteries on the market, the BP-98UX uses the original battery contacts to provide power, rather than a flying lead connected to the devices DC power input. The built-in Total Battery Protection system offers over discharge / voltage protection (If placed on unsuitable / incorrect charger), short circuit protection and thermal protection. Dual Power-con (D-Tap) power outputs regulated from 11-17v was also added. Weight: 440gSize: 9.2 cm x 3.9 cm x 7 cm Current: 6.8Ah

SHAPE BP-U65 lithium-ion two batteries with dual LCD charger SKU: BPU2B Two 65Wh 5200 mAh Batteries. D-tap output (14.8V / 5 amps). 16.8V Charger. Charge Two Batteries Simultaneously. Clear LCD Charger Display. USB Output to Charge Accessories. AC Power Cables Included. 1-year limited warranty on all manufacturer defects. SHAPE BP-U65 lithium-ion battery pack 14.8 V 5200 mAh (BPU65) The SHAPE 65Wh BP-U65 Lithium-Ion Battery is designed for Sony BP-U type mounts which power Sony PMW or PXW series cameras. This 14.8 V, 5200 mAh battery has no memory effect and is decoded so it can be fully charged with accurate power metering. A D-Tap output is provided to charge video accessories or the camera, and a 5V USB port is provided for charging smartphones or onset mobile devices. Both ports can also be used to charge the battery with a USB or D-Tap power source. Battery capacity can be quickly checked via the 4-segment LED meter. The battery’s box-like design can be easily stacked for storage or packed away in a case for transport. Compatible Sony Cameras PXW-FX9 PXW-FS5, PXW-FS7, PXW-FS7M2 PXW-X180 PMW-100, PMW-150, PMW-150P, PMW-160, PMW-200, PMW-300 PMW-EX1, PMW-EX1R, PMW-EX3, PMW-EX3R, PMW-EX160, PMW-EX260, PMW-EX280 PMW-F3, PMW-F3K, PMW-F3L PXW-Z190, PXW-Z280 SHAPE BP-U dual LCD charger (BPUCH) Insert the battery into the charger plate. The charger will detect the load and start pre-charging. When fully charged, remove the battery from the plate. Dual charging port designed to charge two batteries at the same time;Wide range compatibility of charge (8.4 V / 12.6 V / 16.8 V);Intelligent MCU control identify the voltage of the battery and prevent overcharge;Charger plate is suitable for most Sony camera/camcorder batteries; (Some BPU Sony batteries may not be compatible.)USB Output, perfect to charge your smartphone and other USB devices when the AC is plug to the wall;LCD display the percentage of power level and current mode;Charging method is CC/CV (Constant Current / Constant Voltage) with high efficiency;Pre-charging feature allows to extend battery life. Input and cables AC 100V-240V 50/60 Hz 1500 mA (Max)(1) AC cableOutput Output current mode (H): High current charging mode, 1.5A for 1 battery or 0.8A for 2;Output current mode (L): Lower current charging mode, 1A for 1 battery or 0.5A for 2;USB Output: 5 V 2100 mA (perfect to charge your cell phone when plugged to the wall).

Hedbox HED-BP75D Hedbox HED-BP75D is a high-capacity, lithium-ion Battery Pack can Power any Sony HD Camcorder like: PMW-EX1PMW-EX1RPMW-EX3PMW-100PMW-150PMW-200PMW-300PMW-F3PXW-X160PXW-X180PXW-X200PXW-FS7 that accepting the BPU style Battery Packs. It also have external Power output on USB 5V , 1A for all USB Powered Devices, and Dual D-Tap DC 14.4V Power Output that can deliver 75W / 8A to all Professional external Devices. Bulid-in Dual D-Tap 14.4V, 8A 75W Output Socket Dual D-tap DC output socket is equipped on the top of HED-BP75D Battery Pack, With this external Power supply facility, you can connect two different products like on-camera LED light and Video Monitor or Wireless Transmitter and Digital recorder, and get power simultaneously together with Battery attached to the Camera, or totally separately like independent Power Station. The Max power from two D-tap is 75W. The opposite orientation of D-Tap connectors provide, more flexibility during every day operation. LED Monitor Indicator Battery Pack have build in 4-LED Power Monitor indicator that, upon the press of test button, shows whether 100%, 75%, 50%, or 25% of power is left remaining in the battery. Build-in USB 5V, 1A Socket To Power external Electronic Devices that can be powered with USB Power, we designed the USB 5V, 1A Output. With this function you can use HED-BP75D like Power Station to charge your Cell Phone or Pad, or any other Electronic Devices that can be powered with USB 5V Power. Data Communication with Camcorder With data communication chip that is build in, the remind power from the battery is exact displayed on the Camcorder LCD monitor.

Core SWX NANO-U98 The Nano-M series addresses the need for a more “pro” style option of power for Small Form Cine cameras. The Nano-U98 is specifically designed for select Sony PMW/PXW Camcorders such as the Sony PXW-FS5. They are equipped with a 4-stage LED gauge, P-tap, and USB port. The P-Tap is a Smart Tap that is able to carry SMBUS/smart battery data which is a featured part of future integration. This power tap will serve as a standard powertap without need of special cabling. These packs charge on OEM Sony chargers. SPECS Capacity: 98wh (14.8v, 6600mah)Size: 17,78 cm x 6,60 cm x 4,19 cmWeight: 0,41 kgNormal Runtime: 8hrs. based off of Sony FS5 draw

Blueshape BPU 90 Battery Pack 96Wh SKU: BPU90 Blueshape BPU90 battery is compatible with Sony 14,4V 6700mAh, Sony BPU-90 and equivalent, 96Wh - 1 DTAP + 1 USB with LEDs Features Charge Indicator (4-Step LED) 1x D-Tap 1x USB (Type A) Technical Data Nominal Voltage 14,4V Charge Capacity 6700mAh Energy Capacity 96Wh Size: 41,6 mm x 69,6 mm x 120 mm Weight 418g